Here are some logs of my new combo. te44, 3in thdp, test pipe with cutout, 42lb injectors, and alky chip. This is the first time iv driven it as well as use the PL. Also something wierd is that the car wont boost over 16 lbs got the wstegat rod torqued down as well as my mbc all the way in. with the mbc i used to get 25+ only ran 22 though. Then one day the boost just fell off while driving almost like a vac line popped off. This was before the new mods and now still doing it with the new mods.
PL files with new mods
- Thread starter djj624
- Start date
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
- Joined
- Feb 18, 2006
- Messages
- 10,084
With just a quick comb over, the logs look o.k.
Sounds like the boost controller is jacked up. It's sending full boost to the actuator. Pull the controller and do some testing on it.
Sounds like the boost controller is jacked up. It's sending full boost to the actuator. Pull the controller and do some testing on it.
Hey TurboBuRick you were right about the controller. I took it apart and found that one of the balls got stuck inside the spring
.. This is not an RJC controller and it uses 2 different size balls top and bottom with a spring in the middle unfortunatly the bottom ball is smaller than the top so i pinched the spring end a little to ensure it wont happen again. Havent gotten to test it yet bt im guessing that was it.
.. This is not an RJC controller and it uses 2 different size balls top and bottom with a spring in the middle unfortunatly the bottom ball is smaller than the top so i pinched the spring end a little to ensure it wont happen again. Havent gotten to test it yet bt im guessing that was it.Similar threads
