Please help identify

[Kevin87TurboT]

This turbo was on a GN I recently purchased. I'm not sure about the specifics, other than it has a Precision .63 AR exhaust housing with turbo Buick flange. It has a Garrett compressor housing with an inducer around 63mm or so. im not sure where it came from. Has anyone got any ideas? Thanks!

 

[cliffes86gn]

looks and sounds like the one on my car....look for my for post about needing help id'ing my turbo, lots of good info there

 

[bison]

I tried to reply to this before on my phone but apparently it didnt go through. Most likely a Garrett 63 compressor with a clipped p trim turbine. This is the T04s04 cover with the large diffuser. The turbo will support enough power to run low 10's. It needs a 3200@0 stall to spool decently. If the back plate is billet and the flange on the cover hasnt been machined too deep id take it off your hands. Let me know.