I mentioned in my last thread that I am pulling my motor and being that this is my first ECM controlled project car, I was having some difficulty with the sensors and electrical work. A few people offered me some great advice and I took it. I identified and labelled each connection i could.

This, I'm sure will be very helpful when i put the motor back in in a couple weeks. There's still a couple things that I'm unsure of however. I looked over a diagram someone linked to me, but I wasnt confident.
These next two things were located in the rear of engine bay by the ignition coil.
I don't have any idea what this is. It was found as is with no lines going to the nipples and it has a filter (maybe charcoal? Smog related like an EGR solenoid???)

This next sensor was in the same area, and i''m thinking maybe TCC? It was also unplugged.

Thank you for the help.

This, I'm sure will be very helpful when i put the motor back in in a couple weeks. There's still a couple things that I'm unsure of however. I looked over a diagram someone linked to me, but I wasnt confident.
These next two things were located in the rear of engine bay by the ignition coil.
I don't have any idea what this is. It was found as is with no lines going to the nipples and it has a filter (maybe charcoal? Smog related like an EGR solenoid???)

This next sensor was in the same area, and i''m thinking maybe TCC? It was also unplugged.

Thank you for the help.