Powerlogger and Max-Effort thumbwheel

[toomanymodz]

I just installed the Powerlogger and hooked it up to my new Acer laptop. The software looks way better than the old Turbolink software that I used to run.

One thing that I'm not seeing is how do I adjust the parameters on my 16-position thumbwheel chip? With the old Turbolink, I could see each value as I turned the thumbwheel, but I don't see the values anywhere on the powerlogger screens. This is something I need because I need to set my idle fuel and cruise fuel parameters. Any ideas??

 

[Eric Stage I]

You can see all your parameters at once on the BLM grid on the data page. Starting at the top left of the grid is position 0, position 1 is next to the right, and so on.
Eric

 

[toomanymodz]

Ok super! I'll check it out this evening. I remember seeing the BLM blocks but didn't look closely enough I guess. I was looking for a value to change when I rolled the thumbwheel. But it makes sense now if they're all displaying at once. Cool. Thanks!