Hey Everyone,
My Scanmaster is reading about -35 at idle. When I use the PowerLogger it reads about 16 which is within a couple of inches of my vacuum / boost gage so that seems right.
I found that the PowerLogger was set for a 3-bar MAP sensor so I changed that to the correct 2-bar setting. The PowerLogger shows about 0.8 volts at idle.
I turned off then back on the MAP setting in the scanmaster section but nothing changed.
What's the latest version of PowerLogger software? I have 1.3.3.
Any ideas????
My Scanmaster is reading about -35 at idle. When I use the PowerLogger it reads about 16 which is within a couple of inches of my vacuum / boost gage so that seems right.
I found that the PowerLogger was set for a 3-bar MAP sensor so I changed that to the correct 2-bar setting. The PowerLogger shows about 0.8 volts at idle.
I turned off then back on the MAP setting in the scanmaster section but nothing changed.
What's the latest version of PowerLogger software? I have 1.3.3.
Any ideas????
