Well, I've got the new oil feed/drain stainless steel braided lines on and the turbo (TE-60) mounted onto the header. After lunch, I'm going to finish mounting the intercooler (the brackets are mounted) and then clock the turbo and connect the hoses. The downpipe is in place but not bolted up but that will only take a few minutes to finish after I put the dump tube on. Last will be the new MAF Pipe and cold air induction kit.
The Alky kit should be here later this week so that one's going to have to wait.
But HOPEFULLY, I'll have her running in a couple of hours and do some rough tuning tonight (assuming no leaks or probs)! Then, it's off to Norwalk tomorrow morning for some runs and good times!
The Alky kit should be here later this week so that one's going to have to wait.
But HOPEFULLY, I'll have her running in a couple of hours and do some rough tuning tonight (assuming no leaks or probs)! Then, it's off to Norwalk tomorrow morning for some runs and good times!
