Radio bezel, dash cage and pulse wiper

[ravege]

Looking for radio bezel in good shape and all prongs that hold the metal clip thingies intact.
Now the hard part. The metal “cage” that the bezel pops into. I think that can only be removed with the entire dash removed. Previous owner had some aftermarket set up that he had to hack the cage and the bezel prongs.
Also looking for a pulse/delay wiper. I understand just a cover is required, but either whole unit or just cover is fine.

Thanks!

 

[grass doctor]

I know where some dashes are where the cage you need in northern ca

 

[ravege]

I know where some dashes are where the cage you need in northern ca

Interested! PM me the details when you can. Thank you!

 

[grass doctor]

ok

 

[grass doctor]

sent you pm ,

 

[N2BUICK]

I have more this one has all the back tabs but extra holes?

 

[grass doctor]

he's looking for the actual metal frame inside that holds radio

 

[N2BUICK]

Hes looking for both the way i read it?

 

[grass doctor]

LOL I just re read his post duh !!

 

[grass doctor]

I was distracted getting my smoker ready for some ribs

 

[N2BUICK]

Sorry that's a bezel but not radio will get back

 

[TurboWh1]

Got the radio bezel. Are you looking for the delay wiper motor assembly? I have that as well.

 

[ravege]

Got the radio bezel. Are you looking for the delay wiper motor assembly? I have that as well.

Yes to both, PM me at your convenience. Thank you!

 

[N2BUICK]

Are you still looking for the metal cage?

 

[ravege]

Are you still looking for the metal cage?

Yes, do you have one that’s been extracted from the console/dash?

 

[N2BUICK]

Yes i believe i do. I can go to my storage to check soon.

 

[N2BUICK]

No success , will be on look out for this part

 

[ravege]

No success , will be on look out for this part

OK, thanks!

 

[turbohh]

I have this one ... It needs a good going over with a wire brush, but it's solid. The cigarette lighter is toast, but maybe you can re-use yours, or use this one cosmetically for a bit until a nicer one shows up. It used to be a lot uglier, but I soaked this part in a mild vinegar bath and wire brushed off the major surface rust. It's been sitting for a couple of months since then, so some surface rust has reappeared. PM me if interested, and I'll need to know your ship to addy as I'll eat the shipping in my ask ...
Sincerely,
John A, Turbohh