Razor's alky and Eric Marshall's chip

[Super6]

Just got done installing the PAC alky kit and put one of Turbo Tweaks chips in. All i can say is AWESOME. Car runs great and the alky kit was a breeze to put in...Great instructions there Julio Now i can ride around and not have to worry about where i can find some C16 ........................thanks guys ......Bob

 

[Razor]

Be sure to look me up at Reynolds. Glad its increased your smiles per gallon

 

[Super6]

results

Just got back from Reynolds.1st run i ran a 12.488 at 111.57 mph...60 ft was a bad 1.872 leaving with no boost. i had to drive 2 and half hours so i didn't lean it too bad. 2nd run i ran a 12.697 but a worse 1.933 60ft. i blew the tires away trying to leave with 5 psi of boost. i got the same 111.30 mph though..Wish i could have ran friday night when it was cool . i am ordering some slicks soon The car picked up 24 mph from the 1/8 to the end . i thought that was pretty good. Julio i will call you monday about the chip and thanks again...................................Bob

 

[GN owner]

Bob,

What kind of tires were you using for your test and tune session?

 

[Super6]

bfg dr

drag radials 275 50 ....i didn't air them down,had them at 35psi i think i i would do better with a taller tire maybe like a 275 60....if everything works out i am going to the local track thursday night when it is really cold to see if i can get this thing in the 12 o's .Bob

 

[Razor]

Hey Bob, congrats. Drop me a call early next week and I'll get the higher timing chip out to ya.

Some slicks.. a 10-12 PSI launch.. your there.

12.4 on a stock turbo and drag radials.. not too shaby