Roll Bar Distributor

[Raymond Bunch]

Well it that time to finally install a roll bar. I went with an S&W roll bar on my last install and it turned out good. Not to much of a headace.

This time I plan on doing a Chrome Moly and was wondering who else out there sales them? I'm going with a 6 point.

 

[86brick]

Call Ernie McDaniel at 954-791-9371... He is down here in south Florida and makes a nice custom fit chromoly rollbar kit for our cars...

 

[Mac in SD]

Ray, check out Autopower in San Diego. They specialize in bolt-in bars for SCCA etc., but I know they have done G-body bars in the past. Just don't know if they do weld-in chromemoly.

 

[Raymond Bunch]

Originally posted by Mac in SD
Ray, check out Autopower in San Diego. They specialize in bolt-in bars for SCCA etc., but I know they have done G-body bars in the past. Just don't know if they do weld-in chromemoly.

Thanks for the heads up, I'll give'em a shout tomorrow

 

[Raymond Bunch]

86brick

Originally posted by 86brick
Call Ernie McDaniel at 954-791-9371... He is down here in south Florida and makes a nice custom fit chromoly rollbar kit for our cars...

I will also give them a try, thank for the reply. Ray

 

[Fuelie600]

Find anything Ray? Brian

 

[86brick]

FWIW Nick Micale, azgn, and a few other board members are using Ernie's rollbar and can comment on the quality and fit of it... Probably should have mentioned that in my first post, but hey better late than never

 

[Reaper]

Originally posted by 86brick
FWIW Nick Micale, azgn, and a few other board members are using Ernie's rollbar and can comment on the quality and fit of it... Probably should have mentioned that in my first post, but hey better late than never

Brick just about ever car in the phoenix metro area with a bar in it is running Ernies bar

 

[MSDGN]

I have Ernie's bar...nice piece...excellent fit...swing-outs on both sides...had it powdercoated grey to match the interior...very stealthy...have had a lot of compliments...

 

[Raymond Bunch]

Well got a little side tracked the last couple of days. Ernie is who I am going with since you guy's think pretty highly of him. I'll give him a call tomorrow. Any Idea of how much a chromoly 8 point will cost? Also, does he have a website? Thanks.

 

[86brick]

No website as far as I know... I'm sure if you gave him a call he could tell ya how much a chromoly 8 point would cost... The rollbar is legal down to 9.99 so if you don't plan to go any faster you won't need the 8 point (cage)...

 

[Raymond Bunch]

Originally posted by 86brick
No website as far as I know... I'm sure if you gave him a call he could tell ya how much a chromoly 8 point would cost... The rollbar is legal down to 9.99 so if you don't plan to go any faster you won't need the 8 point (cage)...

Thanks! I might just stick with a 6 point for now and upgrade later on when it's time to go faster. Thanks Again.

 

[Fuelie600]

Is Ernies bar a bolt in or weld in? Thanks

 

[86brick]

Originally posted by Fuelie600
Is Ernies bar a bolt in or weld in? Thanks

Weld in.... A bolt in bar is NOT legal!