Scanmaster 2.1 and Turbolink No Comm. W/ECM?

[StearmanR985]

Hi,

I have a Scanmaster which stopped working a while back. It does have power but once the '2.1' goes off, the screen is blank, no readings.

I also have Turbolink and after following the directions and hooking up I get a message that it is not communicating with the ECM. On the computer screen I get a green light on the Comm 1 but a red on the ECM communication.

The car starts right up and runs but runs rich with a high idle and the check engine light is on. These symptons was a very sudden occurrence two-three days ago.

Any help on this one?

Thanks,
Jeff

 

[StearmanR985]

Anyone? I think my poor car is tired of sitting in the garage with the dog....