Scanmaster Intalled!! Here the numbers..

[LS954]

Just finished installing my scanmaster 2.1 along with the TT street chip that was installed last night. Here are the numbers i took of the car while at idle and up to temp.
O2- Fluctuates
AF-05
L8-Fluctuates
BAT-13.8
INT-128
BL-130
MPH-0
CLT-162
ATS-62
RPM-750-875
TPS-.48
IAC-50
CC-190

I drove the car up to almost 12lbs of boost with no knock. Once i get it on a longer stretch of road ill open her up a bit more to see if she is knocking or not and also get a better idea of what the o2 is looking like. What do you guys think?

 

[NJ Torque]

Lower TPS a bit to .42/44

 

[87NAT]

IAC just a hair to high. Look up the spring cleaning guide on gnttype. website.

You will find the IAC reset procedures there.

You should get at least 17-18 psi with no knock on a good batch of gas. Back in the day I could run 20 psi on pump gas..of course I was 19 years old...no scanmaster...no knock guage...etc...I dont know if I was just lucky or a master tuner.

 

["Turbo-T"]

Back in the day I could run 20 psi on pump gas..

Damn how back are you talking???

I run 93 octane and my Scanmaster will put out a 1 or 2 reading if I really start getting into it all of the sudden. And I'm only pushing 14-15 PSI boost.

 

[87NAT]

1993-94. Read my post again. I probably had all kinds of knock and I didnt hear it or didnt know what to listen for in the first place. I was just lucky all around with that first TR. Looking back I probabaly damgaed that motor somehow....

"Ignorance is bliss"

 

[87geeinn]

Numbers look real good. As mentioned before, you might want to ever so slightly tilt the TPS until it reads between .42-.46 but it may still be within specs. Your IAC's are fine if the off idle response feels o.k.