scanmaster numbers

[1dollardog]

Ok here are my new numbers after some tuning and tweaking SM2.0:
o2 011-222 (stays pretty low but occasionally jumps up)
af 05
L8 26
Bat 13.6
Int 128
Blm 133
Mph 00
Clt 193
Ats 71
R 975
Tps 46/480
Iac 00
Mal 23

What is off and what do I need to do to bring it back to good?

 

[SS/GN]

For starters you have a code 23=air temp sensor
tps should be .42 prefered and IAC should be 10 to30.
check temp sensor for unplugged or bad wire.

Kevin

 

[dpasadena]

For a 160 thermostat your water temp seems a tad high to me. my water temp never gets that high even in 100 degree weather in traffic

 

[1dollardog]

I think the air temp sensor code can be explained, I don't have one haha. It is a hot air and at the time I was using a chip that didn't have it burned out. I have my electric fan (adjustable thermostat) set a little hot right now. When I have it set to come on earlier it never gets that hot sitting still. It shoots back down to 160-168 when fan is on. Iac I purposly set a low because of a high idle problem that I'm trying to work out. How about the o2 and blm, do they look normal? o2 stays right around the low number but jumps up for a split second.
Thanks