SD2 chip from one computer to another

greeneyegi

Well-Known Member
Feb 21, 2010
1,281
188
63
N CAlifornia
Ive finally got a gremlin figured out to the computer setup I have.
Its a stock computer with Powerlogger, Turbo Bob updated injector
drivers, and sd2.
After running it will flood out and run rich. Then sometimes runs fine.
Took to tuner got tuned and after 20 miles it would load up etc.
They swapped computers that i bummed from turboTguy Thanks bro
It never skipped a beat.
My question is can i take the chip out of one computer
to another and the tune stays?
Im looking to find a good combo ecu and PL
Ive got a few to try.
thanks
 

earlbrown

runs with scissors
May 26, 2001
7,301
1,436
113
48
lagrange, GA
If you need special drivers inside the ECM, you can't just grab another computer and move the chip over.

Well... actually you can... And it'll work until the lower powered drivers let the smoke out.
 

greeneyegi

Well-Known Member
Feb 21, 2010
1,281
188
63
N CAlifornia
If you need special drivers inside the ECM, you can't just grab another computer and move the chip over.

Well... actually you can... And it'll work until the lower powered drivers let the smoke out.
As long as the injectors are low impedance it shouldnt matter if i use stock computer correct?
 
Last edited: