You can type here any text you want

Stage II 4.1 rods and pistons ???

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

texasturbo

Member
Joined
Jun 25, 2001
Messages
165
I am curious what combo any of you have used with good results. I currently have a 4.1 on-center, stock deck, stock bore and a BMS 3.625 crank. My questions is what rods( length and manufacturer ) and pistons have you all had good luck with??? Also, what about rings ?????
 
texasturbo said:
I am curious what combo any of you have used with good results. I currently have a 4.1 on-center, stock deck, stock bore and a BMS 3.625 crank. My questions is what rods( length and manufacturer ) and pistons have you all had good luck with??? Also, what about rings ?????

6 to 6.5 in length

oliver or corrillo

Is your crank widr or narrow journal. I have a good set of narrow corrillo 6.5's for sale.

CC
 
I'd go with the 6.0" or 6.25" rods to keep the pin out of the oil ring on the pistons, though this is mainly a concern if the motor is for the street. Race it doesn't matter so much and you can run a vacuum pump to get even better ring seal.
 
Back
Top