Switching to Wide Band - Setup?

[odium]

I am running on a typical scanmaster and seat of the pants tuning system right now and would like to make the switch to using wideband input.

What do I do so I can use the wideband input to automatically adjust parameters?

TT6.0 w/ Wideband input?
SD chip? What other parts will I need?

What and why?

I have an LC-1 wideband system (no gauge) sitting here in a box unused.

 

[Beamer]

The TT6.0 chip is supposed to work very well.

You will still need some sort of system to confirm your WB numbers. A display runs around $100, I believe. You could also look into the powerlogger system, which will give the data through the scanmaster, and drastically improve your display frequency rate. Atop that, you can record your runs and determine what may be going on during your runs.

Just a few thoughts...