Trans pan cork gasket; install dry or w/silicone?

[movinfast]

I’m putting new axels in my rear end. I need to buy moser axels (a102808) and the bearings. what is the correct I.d for the bearings? I saw one that was 1.4000 and another that was 2.400. I’m purchasing from summit racing because it’s free shipping.


Sent from my iPhone using Tapatalk

 

[pacecarta]

https://www.summitracing.com/parts/msr-9563/applications

youll also need wheel studs for the new axles as well as a seal for the rear cover and fyi half the gn rears i pull apart the retainer bolt for the cross pin is snapped off at the last thread leaving the pin end and a thread stuck in the carrier preventing the cross pin removal which needs to come out to remove the c-clips , always good yo have a spare retainer bolt on hand and some cusswords as you try to get the broken half out

 

[movinfast]

Ok so I found out it’s 1.4000. What do you guys think of moser bearings


Sent from my iPhone using Tapatalk

 

[pacecarta]

im out...... i gave you the link

 

[movinfast]

im out...... i gave you the link

Thanks. Your message didn’t pop up till now.


Sent from my iPhone using Tapatalk

 

[dvernst]

I’m putting new axels in my rear end. I need to buy moser axels (a102808) and the bearings. what is the correct I.d for the bearings? I saw one that was 1.4000 and another that was 2.400. I’m purchasing from summit racing because it’s free shipping.


Sent from my iPhone using Tapatalk

I ordered the axle shafts from Summit, and the bearings, and studs from Moser. Saved me $20 in shipping

 

[Pronto]

Yup, cross pin was broke on mine.

 

[conn84gn]

I changed the C Clips at the same time with the same axles bearings etc. from Summit
along with rear disc brake converstion