transbrake with 2 step

[bttwracing86T]

so I am going to be ordering hopefully next week a stage 2 transmission with electric transbrake, deep pan, from Lonnie. and probably a 2 step from full throttle. how hard is it to install 2 step. never done one before. and what do I need to do with my drive shaft to hold the power that the tbrake is gonna push. do I need a new one rebuild stock with heavy duty joints or what. any infor would be great thanks. I am looking forward to getting the beast a new transmission and launching like hell

 

[Eticket]

Ideally, you need an upgraded driveshaft with billet trans yoke (strange makes one for th350 that works). I might actually have a solution for you....almost new driveshaft (contemplating selling) it is stock length 3.5" chromoly with 1350 joints (you can use a conversion joint in the back).

Two step is a very very easy install.

PM for details if interested.

 

[Chuck Leeper]

MW makes a billet pinion yoke..Nice piece, not cheap.

 

[northerngn]

2 step goes in easy and i bought my yoke (strange brand) from summit
just look one up for a th350 or a powerglide...same spline count!