You can type here any text you want

TunerPro RT bluetoothed to SCMG minor issue

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

TurboDave

RIP DAVE
Staff member
TurboBuick.Com Supporter!
Joined
May 24, 2001
Messages
14,013
OK TunerPro RT experts, what am I doing wrong??
I have been successful in getting the Scanmaster G to talk to TunerPro RT via Bluetooth. All seems well except for one particular data point.
My issue is, the Boost isn't reading correctly, while everything else on the TPRT dash is reading perfectly.

At key on engine off, you can see in the picture that all but boost are reading correctly and they agree perfectly with what the SCMG is showing.

Boost on the SCMG reads 0.0, while the tunerpro is showing -10.5 I must have something set wrong, any ideas?????

I just can't figure out why the data going into TPRT is good except for the boost. I must have something set wrong.

I should also add that the adx file I created started out as SCMG_BT_001
It's the only adx file for the SCMG that I could find that had turbo boost as an available value.


TPRT SCMG dash.jpg
 
Last edited:
Is that with key on not running? 100kpa is 0 vac 0 boost. What bar map are you using and what bar map is the TunerPro set up for? I have TunerPro on my lap top but I don't have the gauges, just shows the numeric like your bottom row.
 
record a log and then send the log and the adx to me

Bob
 
Is that with key on not running? 100kpa is 0 vac 0 boost. What bar map are you using and what bar map is the TunerPro set up for? I have TunerPro on my lap top but I don't have the gauges, just shows the numeric like your bottom row.
I'm pretty sure 0 boost/vac and 100kpa are only true at sea level. We're at 1,000 ft here. Every barometric device in the house agree at about 95 kpa here. I have a 3 bar map. Other than setting the upper and lower limits of the gauge in tuner pro, I'm unaware of any other way for it to know what map I'm running.
Yes the screen shot is key on engine off.


Sent from my iPhone using Tapatalk
 
All maps 1,2,or 3 bar all put out 0-5 volts so I guess it goes with the gauge setup.
 
Looked on tunerpro forum but didn't see nothing.
 
Ya, it's an odd problem. SCMG and powerlogger both read 0 boost koeo. So why isn't that same data showing on TunerPro? As can be seen on the pic I have the boost gauge upper and lower limits set for 3 bars. I'm stumped.


Sent from my iPhone using Tapatalk
 
I wonder if this could be my issue? Could TunerPro be looking at the wrong bit of data? Took the car out for a blast, and while running 21# of boost, tunerpro only got as high as -4.5#

adx edit.jpg
 
Im sure its an adx file issue. I will chase it down and let you know.

Thanks

B
 
Back
Top