I have a turbo oil feed line leak at the nut. The leak is located at the brass block oil pressure sensor connection on the passengers side engine block. Any tips on fixing this leak? It’s difficult to put a wrench or flare nut wrench on it but I’ve managed to do it. I’ve tightened it a little bit, but it still leaks. Any tips on how to move forward is appreciated. Thanks.
Turbo feed line leak
- Thread starter crisp76
- Start date
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
salvageV6
Daily Driver
- Joined
- May 25, 2001
- Messages
- 21,012
If you can get it off you should check both the block brass fitting and the feed line for debris or a tiny crack.
Other than that loosen it and rotate it slightly which might clear the debris or allow the flare to re-seat better.
Other than that loosen it and rotate it slightly which might clear the debris or allow the flare to re-seat better.
