I'm looking to install a AEM Oil Pressure Sensor (1/8" NPT) to the oil feed line that sits atop the Turbo using a couple brass fittings:
1. Inverted Flare Fitting, Brake Line Adapter, Male Connector, 1/4" Tube OD x 1/8" NPT Male &
2. Brass Street Tee 1/8" NPT Female x 1/8" NPT Male x 1/8" NPT Female, Male Run Tee 3-Way Pipe Fitting
3. And maybe needed 45 Degree Street Elbow 1/8" NPT Male x 1/8" NPT Female Brass
Is there any con's to placing the Pressure Sensor here rather than down at the other end of the oil feed line by the Oil Pressure Switch ???
Is there too much vibration atop the turbo?
All opinions much appreciated.