Where to route the pump wire for my Alkycontrol kit?

["Turbo-T"]

I am in the process of installing an Alky control kit.

I noticed the pump comes with a pretty long 3 wire set up.

I am considering running it across the underside of the bumper, then coming thru the radiator core support on the driver side, up along the side of the inner fender, then down under the wiper motor before drilling a hole in the firewall just above the speedo cable area.

But before I do this I wanted to ask if there's a better way to route the wire?

Thanks!

 

[87GNSteve]

I ran mine along the passenger side fender across the A/C blower box behind the intake/coil along the oval wire loom and into the fire wall next to where the speedo cable goes through.
Using the black wire loom it makes it pretty invisible.
Pretty much ran it alongside the factory wires and wire tied them together every so often.

 

[Razor]

I ran mine along the passenger side fender across the A/C blower box behind the intake/coil along the oval wire loom and into the fire wall next to where the speedo cable goes through.
Using the black wire loom it makes it pretty invisible.
Pretty much ran it alongside the factory wires and wire tied them together every so often.

+1 passenger side. I run them through the inner fender and come out by the battery. Then underneath the alky/coolant tank.. past the 3 bar sensor, by the AC box.. behind the coil pack.. in through the factor rubber grommet on the drivers side firewall. Plus this way when you tap into the 3 bar MAP wire, its next to the loom.. and when you run the low level wiring from the tank.. same thing.

HTH

 

["Turbo-T"]

Thanks Julio I think I will go this route.

Also is the green wire on the original MAP sensor harness the only wire to tap into?

Thanks again.

 

[Razor]

Thanks Julio I think I will go this route.

Also is the green wire on the original MAP sensor harness the only wire to tap into?

Thanks again.

Yes. only one. You can also tap into it behind the glove box on the mating plug.. but if your wiring challenged.. just get it by the 3 bar MAP.

HTH