Recent content by 87 gnash

marks set up is tops. installed in an hour (and i am a learning mechanic) and have no problems... oh yea, except for that increased boost and hp ;)

hello all - i took off my glove box due to a slight discolorization around the knob that now appears to be rust. apparently it is worn down to the metal from use. my intentions are to clean it, but was wondering if anyone had any luck repainting.. and if so, what to use.... many thanks to...

thanks jay... but you are talking way above my head russ understands where i am ... in terms of knowledge / desire :D

yes, it is a stock fuel pump many thanks for taking your time here....

not really i guess.. it runs well, but sometimes hesitates under boost conditions... i have been told by so many that i will have a detination problem with the stock engine and the air adjustments i have made.. but as i said, i really only drive for fun and the love of these cars.. this is my...

i have a 87 stock paint gn... i have searched and read many posts about the best wax, but still uncertain... what does anyone suggest? paint has the regular flaws and **** undercoat markings below door strips.. but hood and roof have been kept up well, and i would like to continue this ...

have a 87 gn that is mainly stock... except for big mouth air intake, with terry downpipe and atr dual exhuast... i have been told i should change fuel injectors and possibly upgrade wires..... i am learning as i go and am at the base level of knowledge... and also would like to keep the...

thanks bones - could not imagine what was going on.. thanks again

just put on big mouth air kit.. drove about 5 miles (getting on it a bit)...stock 87 GN with no other mods and 44 k miles when i brought the car back and touched the bottom of the new k&n filter, it appeared to have a slight coat of trans oil (i think).. what is wrong here??? any...

thanks guys.. i appreciate it.. i will order it tomorrow...

thanks - is the big mouth that much better? i guess i was looking for the least amount of mods possible... i thought the atr seemed to be least obtrusive... just a bolt on type mod..... am i wrong?

am looking at purchasing an atr intake on my completely stock 87 GN... i do not want to alter anything else as i am still learning and i would like to keep the rest within my reach right now... if i do this, will i have to make other adjustments with this unit (ie MAF, O2 sensor problems?)...

i am looking at purchasing an atr intake on my completely stock 87 GN... i do not want to alter anything else as i am still learning and i would like to keep the rest within my reach right now... if i do this, will i have to make other adjustments with this unit (ie MAF, O2 sensor problems?)...

thanks woody i just ordered the the terry houston 3 inch down pipe with cut out... i appreciate the help here.. you just set me straight... i am now going for the atr exhuast.... which one do you recommend of the two 3 inch systems?

ready to purchase kirban 3 inch down and 3inch replacement cat... i am then hooking it up to the ATR 3 inch system.. help me out... is this a good idea... or will i run into any problems