Recent content by Cobia245

I need set of these door panels. Tried to make a set didn't turnout the way i wanted:). please pm me I'm ready to get a set asap thanks.

yes I set the min boost to 0 from the start I need to know how to get the waste gate to start opening sooner. Would more P more I more d work I read a lot on PID but I did not see anything that explain what to do with my problem. What if I ramped the boost table. My thoughts on the boost table...

Min map is at 0 now. I'm not having a problem making boost it a problem over shooting the set point. 100% is when I'm making boost 0% is when its trying lower the boost.

Upgraded from 1.34 to 2.002 and thought I'd try the boost controller. I'm set to Map mode and slew is 1000 Pos. and 1000 Neg. PID is set at P=80 I=30 D=30 and the boost table is set to 65 strait across 0 tps to 100 tps. The problem I'm having is the boost duty cycle stays at 100 until 14.5 psi...

Is this still availble? Is this still available and if so is this still the pricing?

I only bought one new amp to push the new sub. I've got some 6x9's laying around I might put them in. I think i still have an old alpine four chanel laying around to. I didn't want to look for it and hook it up unless it would make a big difference.

Need advice on my front speakers. A little back ground i just replaced my H.U. with a Kenwood KDC-x595 that has (22 watts RMS CEA-2006/50 peak x 4 channels) a JL 10w3v3-2 and a JX500/1 amp. 2 4x10's in the rear running off the H.U. Here's the question going to build speaker pods in the lower...

pm sent

color does not matter gray would be fine looking for cheap ones. Yes to the power locks

Do you have lower door panels

thank guys for checking that saves me alot of head ache

I need to know the mounting length of the stock rear lower control arms. Like a center to center measurement. Thanks for any help.

Hey WSLN you were right the fuse was blown that should fix it. I did check the fuses that night but i did not know that was the one for the solenoid so i said i check all of them but i guess not that well. So I guess all's well that ends well and thank you for help.

Ok I need some help I made a big mistake hooking my XFI up to a boost solenoid. I am using a Casper’s adapter so the solenoid hooks up to the factory wires. Well I tested the boost wires and I had 14vdc on both wires so at that point all was good. Well that’s were it all went bad the solenoid...

I Know this post is old but I've just came across it today. I Know the guy that owns New Beginnings Auto Body he was a neighbor of mine at one time. They do great work there but He not cheap. Also the last time I talk to him he said he was doing insurance work only. No custom paint work.