Recent content by malibu78

Good Evening Members, On 8/2/02 from 12pm-4pm. Royal Oak Middle School will host a car show. Proceeds from the event will be used to purchase computer software for the school. We figured this would be a fun event near the time of the Dream Cruise. The school is located at 709 N...

Tony, Sorry. Guy came and picked it up yesterday. Thanks for expressing interest. I already miss the car. That's Ok, next week I will be ordering my new 421 sbc shortblock for my malibu. Hoping for 9.50's on the bottle.;)

Not only does the wife not like the car I hardly drive it. I have owned the car almost two years and have not put 1000 miles on it. Afraid to drive it anywhere because it is so nice. It's seen the drag strip twice to see what it would run and that's the majority of the driving. Two trips to...

I am scared to lean it out. I appreciate you input from all you. I think for $400 bucks I'll get the 60's. Also I run the slicks of my drag car and I am looking for a drag radial that is a true 28 inches tall for a 16 inch rim. I have gnx rims. Burnt out on swapping tires when I go to the...

Going through at 5000 rpms according to the scantron

c16, if it is straight c16. What I mean by straight is all the other fuel is completely out of the tank not pumped out. There is approximately 3 gallons left in the tank when pumping fuel out via the injector rail. C16 is awesom fuel in terms of preventing detonation. I probably could run...

Bison, I currently have 009's not the 60s. I am wondering if I get 60lbs injectors if it will run in the 10's. I can only get 23.5 lbs of boost and according to Julio's sticky on tuning with a scantron you want your o2's to be 770-780. I figured with the bigger injector I could turn the...

I will let you guys know what happens this spring if I don't sell the car. If I can't sell it by early May, I am going to uprgrade to the motron 60's and have my chip reburnt by Eric at TT. Thanks for the info

I am afraid she'll lean out with 009's. As mentioned before my 02's were 770 at 23.5 lbs with the injectors maxed out and spraying alky full blast with c16 fuel.

You have a bigger turbo, cam, better heads. Do you think I can get into the 10's with my set up and bigger injector?

Fellas, Will a stock long block with valve springs 60lbs injectors and a TE 62 go into the tens on a good air day and traction??? I have gone 11.24 with the te 62, 009 and 23.5 lbs of boost. Car runs with no knock, 770 o2 volts with TT 5.6 chip richened all the way and my alky spraying full...

I think the poster was saying that the clearances for SBC are larger. There are many good machinists when it comes to SBC's. I have an SBC swap meet parts that runs 10.90's on motor and 9.90's on the hose. My opinion and take that with a grain of salt have a buick guy do your machining for a...

Does this machinist have any experience with TR or TTA. If not I would not let him touch the crank. There are a lot of good machinists when it comes to a SBC, but our motors are not SBC. There is a guy on this forum with a stock long block with valve springs and I believe a te61 turbo with 50...

tta 1240, I sent you an e-mail this morning and I just re-sent it let me know if you receive it. thanks,

I sent pictures to you.