Recent content by newwguyy

Has anyone ordered a replacement Mass Airflow Sensor? I need a new one but I am weary of using the local autoparts store as they sell junk.

Any ideas where to look for a wastegate solenoid?? I tried postons, kirbans they only have it for 86-87...I need it for my 84 GN :confused:

I was just going to screw it onto the rail to see what im getting at idle...

I am new to fittings, where should I start with looking for the fitting, and do I just tell them I need a "-4an fitting" ?? thanks for the info :D

:confused: Just got a fuel pressure gauge from SUMMIT, but it only has a male threaded plug coming off the gauge...Does any one know the size of the threaded nipple coming off the fuel inj. rail where the gauge will screw into? I am hoping I can get the fitting locally and not deal with summit...

I have some autolite 24's...what gap for stock application?

what size autolites? what gap? thanks

excellent, where do the actual numbers flash? the other day when I was letting it idle for awhile it sounded loaded up with too rich fuel supply, and the check engine light came on until I drove it... :)

OK, question #10,211... In my ever enduring battle with a rich running, low mileage stock GN...A friend told me to ground some port under the dash and read trouble codes??? this is all new to me and he wasnt sure either...could someone explain how this is done and where the actual numbers of...

I saw that too but it refered to the intercooler 86-87 stuff and I wasnt sure it was interchangable (the info)...just wait, I got another big question brewing :D

stock 84 GN, what is the best spark plug recommendation and gap? Also, fuel filter model #???

thanks nick!

Do I take the valve out with the car off , then screw the fuel pressure gauge on and take the vac line off, then start the car? One last question, do I let the car warm up first before doing the test? Isnt gas going to go everywhere when I take the valve out? kinda like taking one out of a...

about the 9 inch K&N, do you bolt it to anything after removing the box and attaching it at the MAF clamp? or do you just let it hang?

I owe you for all this heads up knowledge...