Recent content by PhilM

That's all fine n dandy, but what did the chiropractor have to say about all of this shinnanigannery. Phil

Yea, I don't think it matters, esp. if the pumps are sealed... the only issue with mounting it 'head up' is if the internal seals do break, I don't think the main front bearing is sealed (?) but don't quote me on that. I tend to mount mine horizontally most often. Phil

I'm using the ICS SCEs... no issues... running a few thousand miles sofar on the build. Just a lil extra ultra copper along galley rail and oil drains, that's all... Phil

Especially for initial tunes I almost always run some sort of race fuel. I like the added protection although race fuel will slightly alter only some minor items in my final tune.

What have you tuned advance by? MBT? If, so I would not vary off MBT tune w/o alky/water until the other parameters were correct (i.e. enough alky is being injected based on your engine, NO knock, etc...) Oh, and I actually saw you were using an M12 (pays to read, eh!). To me, that seems on...

I am a big supporter of EGTs - I've been able to troubleshoot all kinds of situations where the WB wont 'see'. With such a limited selection of tuning tools, you really should have them all at your disposal. Water mixes are pretty weird to get dead-on in my experience. I've tried all kinds of...

Haha, small world... well not really, IEEE is absolutely HUGE nowadays. I work in research and support in a university so IEEE is almost a mandate! Phil

Ahhh, now I remember why I signed up for GNTTYPE's forum.

I was going to come... instead I went to work and stayed out of KY (I've heard stories :) Phil

Got any pix of the smoked hl and pl ? Thanks! Phil

Will ship her out tomorrow morning! Thanks, Phil

Billet vacuum block sitting here (with vacuum brake tap and milled lines on top). I removed 2 of the 5 PS ports and replaced them with setscrew/epoxy since I didn't need all of em. The gasket is included. $15 (should handle shipping and my hassle going to the PO). For some reason this could...

Still avail? If so, put me in line... I need a temp BC till I finish mine up... got some dyno time coming up! : )

I've ordered the sensor for I think 120$... they have a cheaper one but it's less accurate (the 'cheap' one's ONLY 1% FS accuracy :rolleyes: ). They said it'll be ready for me by the end of the month. As far as some readout, I was just going to do a 3 digit 7segment that did different...

Yea, if they're varying solenoid DC, i'd guess their trasducer wouldn't alter pump speed... it can just alter the solenoid DC. If it's closed loop (well with WBO2 input), do you have to even tune it? Phil