You can type here any text you want

Recent content by randymc1

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!
  1. R

    GN1's- Yes or No?

    Get them wire locked and installed by someone who has done them before. You may be sorry if you did have a problem, but atleast you won't regret not doing it later. If you have the cash and wan't the best go get it.
  2. R

    IAC #'s flucuating while cruising?

    I have a good known maf you could try! I don't to much about your transalotor but what does your maf read at full throttle? You can chase this gremlin till the sun don't shine if you don't fix what I would expect to be a bad ground or maybe a crank sensor. Usually the maf work or they don't...
  3. R

    87 limited T-type for sale in Texas

    I got first dibs Bryan! I'm not really trying to hard to sell it!
  4. R

    I Give!!!!! Codes 54,52,51,45,43,42,41,35,33!!!

    Have you replaced the other motor mount and tranny mount yet to eliminate all the movement. If every thing is moving all around you could be chasing one problem to the next forever. Did you pull the engine wiring harness apart and check for partially broken ground wires or wiggle ohm them. Sure...
  5. R

    Clicking noise coming from crank sensor?

    So it ran o.k. till the third pass right. If so I would try a harmonic balancer and new crank sensor. If the balancer gets in to the sensor again then it is rebuild time as mentioned in above reply.I told my dad to mention that I would try the above mentioned the day after you had picked up your...
  6. R

    Same old miss and knock! Help!!!

    You better replace the wires and plugs quickly or as mentioned it will knock out a coil pack. I thought you said you replaced the wires? You said you replaced the plugs also , but if you have a bad plug wire it can cause your plug to foul. You need a good foundation of known good parts to find...
  7. R

    Same old miss and knock! Help!!!

    I would suggest a 3000 stall convertor. It will work with a stock convertor but you will be lagging. R.B. you need to explore you engine wiring harness for damage with all your past engine movement. I would trace your grounds and make sure they are solid first before throwing any more parts at...
  8. R

    Same old miss and knock! Help!!!

    I have a TA60 that has fewer than 500 miles on it I could sale you for five large. I will even install it. If you can leave your car up at my work I will figure it out.Thanks,Randy
  9. R

    87 limited T-type for sale in Texas

    I have a set of 4 welds with tires and the stock rims with tires that go with the car.
  10. R

    87 limited T-type for sale in Texas

    All kinds of extra parts also. Every sensor has been replaced and I replaced the fuel tank is brand new with a double fuel pump setup.
  11. R

    87 limited T-type for sale in Texas

    87 t type Grey with blacked out chrome, Grey leather seats with half console. Weld rims, original block rebuilt with billet main caps,J&E 30 over pistons, 206\206 billet comp cam. T&D roller rockers, Double roller timing chain, new stock crank,New front cover, new water pump, ta63 turbo, 55#...
  12. R

    87 limited T-type for sale in Texas

    Second owner of native Texas car. Car has 133,000 miles and has completely rebuilt to be bullit proof. 1700 miles on motor 1400 miles on th400 w/ precision converter. Grey interiorand exterior with split leather bucket seats and tilt on the column. Car was repainted 6 years ago and in great...
  13. R

    Stall speed problems on the line with 63 turbo

    The 63 with the pte houising doens't seem to take flight till 3900 rpms.Does that seem right? I could be running to rich causing to further slow stall...
  14. R

    th400 goes straight to second gear off the line?

    What is going on? It has a vacuum modulator valve with a one way valve inline to the th400. How to fix please. Randy
Back
Top