I have rebuilt my 200R4 and everything went great and at the same time I am installing a shift kit. I am almost done with everything but I am at a step an stuck big time. I am installing the 2 gaskets and the spacer plate and the instructions say to use the old spacer plate to line up with the new one and mark where to drill a hole and make it the same size hole. Here is my problem somebody (me) threw the original plate away so I do not have it to do this part. I have been able to figure out the location with the paper gaskets but I do not know the size hole to drill. Anyone know the size the hole should be?? BTW I am in the middle doing this right now.