Thank's!
Does anyone have feedback on their 3.5 internal gate downpipe yet? How about puck diameter? Is it larger than a standard 3" puck?
Samballs fell off the face of the Earth last time I heard so I'd hold off on any parts from him.
Good to see more vendors stepping in on the 3.5", there are more coming this summer.
Thank's!
Does anyone have feedback on their 3.5 internal gate downpipe yet? How about puck diameter? Is it larger than a standard 3" puck?
Samballs fell off the face of the Earth last time I heard so I'd hold off on any parts from him.
Puck size on a lot of pipes is 1 3/8th FWIW, if Dan doesn't get back in here with that info I'd just call them but I'd also not worry about it, most never go bigger than 1 1/8th on the exhaust hole anyways.
Good to see more vendors stepping in on the 3.5", there are more coming this summer.
Anyone have any feedback on the BA 3.5 downpipe?
Samballs fell off the face of the Earth last time I heard so I'd hold off on any parts from him.
Puck size on a lot of pipes is 1 3/8th FWIW, if Dan doesn't get back in here with that info I'd just call them but I'd also not worry about it, most never go bigger than 1 1/8th on the exhaust hole anyways.
Good to see more vendors stepping in on the 3.5", there are more coming this summer.
Very nice piece. We had to modify it a bit to fit, but obviously every engine is going to have different motor mounts or condition of mounts. It was close, but needed to be modded just a bit to fit correctly.
Why not make your own Dominic? When I upgrade the turbo I was going to make a 4".