3.5 MAS pipe fit

[hensleyt]

will i need IAC angle boss with Full Throttle Speeds 3.5 MAS pipe

 

[earlbrown]

I didn't know Mike had a 3.5 inch pipe kit.

If it's a normal 3.5 kit, odds are you will need the angle boss.

 

[1KWIKSIX]

I'm running a 3.5" MAF pipe & my turbo has a 4" inlet. I found it did fit without, but was a tight squeeze.
Changed over to the IAC Angle Boss and it's much better now.
FYI.....I tried Champions Angle IAC and didn't much care for the fit. The IAC angle boss in my opinion is a much nicer looking unit and fit my application a lot better to.
"Just sayin"

 

[V6sleeper]

Yes w/4" turbo inlet

 

[1986 Buick GX1]

I run the Full Throttle 3.5 MAF pipe on a TA49 and it clears fine.
I trimmed the 3- 3.5 adapter hose as short as I could.
Because I'm still running a Kenne- bell ram air canister with an 85mm Z06 maf I needed the shorten the Turbo end an inch.
I needed to cut it in half and rotate the filter end .5in clockwise make it line up with the filter canister as well, but I knew I would have to modify it before I bought it due to my set up so no fault on Mike.
It is all welded together and painted so it looks like it came that way.