70 GTQ and RJC billet crank pulley

[Scott Atk]

Precision 70 GTQ, .85, 4"inlet 3"outlet. Tight and ready to run. Has been a best of 9.71. I'll do $600 shipped.

RJC black anodized crank pulley. Brand new only installed for mock-up. Comes with stainless steel bolts and washers. Goes for $169 on Jason's site. I'll do $100 shipped.

 

[Scott Atk]

Pulley is pending payment. Thanks Jack

 

[Scott Atk]

Pulley is sold and shipped.
Anybody want a big HP turbo?

 

[Ed Valvo]

Scott,
Did you need a plenum spacer for the IC pipe to clear the MAF pipe?

 

[Scott Atk]

Ed, I use Mark's (buickgn.com) big mouth setup which uses an angled rubber coupler and a straight pipe. There's no fitment issues with this setup.

Update: Turbo and crank pulley are both sold. Thanks and Merry Christmas!

 

[Monte231SS]

Good deal on that turbo. I would have grabbed it up if it was listed a week later.