9.93 @ 137 1.47 60ft

[mturbo87]

Finally in the 9's with more power left.


RJC intercooler
gtq 70 turbo
109 block 30 over
center billet mains
diamond piston ring combo
stock ported intake
carrilla rods
eagle crank
stock ported heads from Pro Car engine Development
stock rockers with solid shafts
weber roller 224/224 cam set up
stock TB with hemco
ta stainless headers
Janis built 200 r4 trans with brake
Dennys 3" drive shaft,with billet yokes
28 spline moser axles
eaton center
PC non lock up
2 1/2 exaust
3" TH down pipe
Fast XFI
3600 lbs with driver.

 

[rmar]

Congrats, Thats in the 700 + hp club in a 3600 lber.

 

[forcefed3.8's]

Congrats. Tuesday was fun. Very clean set up. Any plans to go out again this year?

 

[GNBRETT]

Congrats...! Not many in that club. Car looks sweet.

 

[turbo6mike]

Man I must of left to early.Good job.Nice car.

 

[Limited87]

Mike, Congrats again!

Cant wait to do more rentals next year! Thanks to all you guys for coming out! Its amazing to see how good a track can be when we control the VHT!:biggrin:

 

[88ZNX]

WOW! Thats almost my combo! Now I know what cam to use

 

[murphster]

Congrats, very similar to my setup too (except that I have stock GN1s).

 

[NCTURBOS]

Congrats Mike!! The looks/runs great!!

K.

 

[mturbo87]

Congrats. Tuesday was fun. Very clean set up. Any plans to go out again this year?

Have to much on my plate right now, this weekend I have to be in Rockingham for the IRHA Nationals. Maybe if we get some good weather after that , I may.

 

[mturbo87]

Thank you all, Could not have done it without help from Bob Hanson, Scott Clairage, Vince Janis and Chuck Wright of Pro Car Engine Development.

 

[viper04]

Congrats, what lbs for boost where you runing?

 

[mturbo87]

Congrats, what lbs for boost where you runing?

28 psi

 

[viper04]

Once again nice, thanks for the reply.