Alky control systems MAP TPS harness

[Alaskabuick]

Installing a kit for a friend and this is a bit different than the ones before, just a bit.

On the Map TPS harness (great idea by the way) what do I do with the original MAP plug on the cars wire harness? If I plug provided one in, how does the cars PC get signal? sorry if I missed something.

Additionally, I am not clear on the directions where the low Alky light red wire or the Power injection red power go to? I would guess that they go to the red on the 6 pin connector? Instuctions mention splicing these in with the main wire red coming from the pump?

Thanks in advance for any help. Ill read them again tonight to see what I missed.


Dennis

 

[Bescurred]

His kit changed a little recently I think...I had to really read through the directions and even called Julio. (He picked up on the first ring) The original MAP plug you can tape it up and tuck it away. It's only job is to light up the LEDs on the factory boost gauge.

 

[Razor]

Tuck away the factory plug. PCM never used it. Easy.
Low level goes behind the "Low Fuel" bottom left indicator. Power Injection bulb gets installed above the check engine.
PI bulb wires across red/black pump wires
Low level red can go to red on 6 pin. Tan goes to tan from tank.

 

[Alaskabuick]

Got it! Actually figured it out and all is welll. Install went good and car ran perfect out of the gate @ 18 lbs of boost.. zero knock and 780's on AF...
Best one I installed to date, nice when that happens!

Thanks,

Dennis