If its 4" wide that's designed for cars running 130+ thru the traps. I've seen twin turbo V3 blow out, Tony had to run thicker gauge tanks. How much did you pay for it?
yes it came with chrome pipes and it is not an ebay hack item item. ask diaz87 about the quality of this ic and piping. this isn't some ebay hack job. you can tell by looking at it in person that somebody put some time into this thing. like i said, the ic is about the same demensions as the rad except it's 4 in deep frnt to bk
One way to be sure is to pressure test it before you install it. A lot of fabricated tanks on A/W units use angle aluminum over all the welded joints. The angle piece is then welded to the unit as well. It is hard to tell from the pic I think, but those welds seem a bit thin.
If you do a pressure test do your self a favor and cap one side FILL WITH WATER then cap other side and pressure up. with water in it IF/WHEN it fails it will just start leaking. If you just cap it and pump in the air IF/WHEN it fails it is much more "impressive"!!! Just a little tip.