Ok guys, I built this rear end to be the baddest of the baddest and now decided that I need to go another route to accomplish my autocross goals. The rear housing has:
1. Thick 1/4" wall tubing
2. Rear braced
3. Big 3/8" ends
4. Billet Fill plug installed
5. Drain plug installed at the back to not interfere with swaybars
6. HR Bar Mounts welded in
7. 12" disc brakes that clear 15" rims
8. E-Brake
9. New Bushings installed
10. Powder Coated Black
I assembled this rear end and put it in my car but havent installed the driveshaft yet so it has never been run on. At this point in time, I'm only selling the housing and brakes but if someone was interested in the whole thing, I might go ahead and sell as a complete unit but I have almost $4K into it complete becuase of the Wavetrac center section (lifetmime Warranty New Technology and BIG MONEY!!), Strange nodular Steel third member, 35 spline Moser axles, etc.
Housing and Brakes is going to be $1200
1. Thick 1/4" wall tubing
2. Rear braced
3. Big 3/8" ends
4. Billet Fill plug installed
5. Drain plug installed at the back to not interfere with swaybars
6. HR Bar Mounts welded in
7. 12" disc brakes that clear 15" rims
8. E-Brake
9. New Bushings installed
10. Powder Coated Black
I assembled this rear end and put it in my car but havent installed the driveshaft yet so it has never been run on. At this point in time, I'm only selling the housing and brakes but if someone was interested in the whole thing, I might go ahead and sell as a complete unit but I have almost $4K into it complete becuase of the Wavetrac center section (lifetmime Warranty New Technology and BIG MONEY!!), Strange nodular Steel third member, 35 spline Moser axles, etc.
Housing and Brakes is going to be $1200
