Bank to Bank Offset distance Off-center block

[CTX-SLPR]

Howdy,

On the chance that someone knows this off the top of thier heads, what is the bank to bank offset distance for production/off-center blocks? I see the refference in the Stage II section that an on-center has 0.120-0.125in greater spacing but no refference to what the baseline is for an off-center block.

Thanks,

 

[turbodave231]

The Block blueprint "X" dimension for #1 cylinder is 1.2900 and #2 cylinder is 2.0300 so the offset is .7400.

Hope that helps

 

[CTX-SLPR]

Thanks Dave! That's what I was looking for. My estimates had it at around 0.840 so good to see I had it in the general range by rough measurements of an intake.