Check ball location on CK plate....is this a problem?

[PaulRV6]

Shown is a photo of the CK separator plate and the 5 check balls. I found the balls in this position after pulling it down. Would this have caused a problem, if so what type of problem? I'm not sure which ones are which but look at the two center ones, they are in the wrong hole. Thanks


paul

 

[pacecarta]

the balls (lo/detent top left , reverse/ 3rd top right ) as they set into the case are in tub shaped pockets
, they should move around and block the port thats not flowing

you could move them over and it wouldnt matter theyll just go where they need to be

 

[PaulRV6]

So you saying that it doesn't matter which hole the ball is blocking off? Cause two of the balls are setting in wrong hole. Thanks

paul

 

[Steve V]

Yes