That's guys for the info. I purchased the ck master rebuild kit , and shift recalibratiin kit also. I did receive his new servo spring and I.have installed it. I have the servo I stalled and there is about .08 to .10in. Of travel when I push in on the servo with the retaining clip installed.
I have read 1 or 2 places that have said they have used extra washers in addition to the 2 proved in the kit. The instructions just say, "install 2 shim if there is too much travel" but don't give any details. (Not helpful)
My band is new and all my soft parts are new, so I was curious to find out what everyone else has done.
Johnt365, you said that your washers needed to total .26in and the each washer in the kit measured .04 and a total of 2 extra washers worked? . , right (brand total of 6 washers)? You said you added 2 more, but don't u mean 4 more? (2 previous washers) that equaled .08 + (4 additional washers @ .04 = .16in. So, .16 + .08 = .24.
So u used a total of 6 washers, right?