Disabling wideband

zapp240

Active Member
#1
I am running a TT6.1 chip with an AEM 30-4110 wb. got in the car today and the wb is going full scale after a few seconds. I believe it may have gone south on me. in order to drive the car, can I set the chip to disable corrections and it should run off the original O2 sensor? using a P/L what value do i put into the first 3 parameters.
 
Last edited:

zapp240

Active Member
#4
ordered the Bosch 17025 from amazon, looks like direct replacement for my AEM 30-4110 sensor . was $30 cheaper than the LSU4.9 AEM offered. back running again. next step is a tune near PGH, was thinking of Lorenz, I believe they have a Dyno.