dyno sim specs

[ITSNOTAGN]

im trying to do some work on dyno sim, but i cant figure out specs on my turbo.
i need numbers for a te44
surge flow
island flow
efficiency
pressure ratio
if you use dyno sim you know what im talking about. thanks guys

 

[JZ 97 SS 1500]

TE44, is pretty much the same thing as a TO4E-60trim. What you need is below....

Click here

Jose

 

[ITSNOTAGN]

thanks, thats cool, but at what points of the graph do i go off of? im not too sure how to get my numbers from that, if anyone knows, a little education would help alot! thanks

 

[JZ 97 SS 1500]

Here is a consumption chart, you will need this for cross reference purposes when looking at the compressor maps.

Click here

Jose

 

[JZ 97 SS 1500]

BTW, this only applies to stock cubes which I assume you have. If not tell me what CI's your motor is and I can develop a custom chart and e-mail it to you.

Jose

 

[ITSNOTAGN]

thanks, my engine is stock as hell. i did figure out how to get the numbers i need, but that is alot easier for sure. ive been working on it, and i think this program is pretty damn accurate. now all i need is stock cam specs. im set up with a 268/268 right now, but i want to put the stock cam in there, but i need either the intake or exhaust centerlines to input the data correctly. by the way, does anyone else out there use the new dynosim?

 

[ITSNOTAGN]

i dont think that graph for the T04E-60 is as close as we think. its topping out at about 45lb/min, and im pretty sure the te44 will push closer to 60lb/min. my calculations have a LC2, at 85% efficiency, 5000rpm, and 24lbs, about 55lb/min, wich i find reasonable.

 

[JZ 97 SS 1500]

The TE44 is rated at 565 crank hp according to PTE. That is about ~51 lbs/min. The T04E is rated at 50lbs/min according to turbonetics and the compressor map. That is pretty close. The next step up would be a TS04, which flows 55 lbs/min.

Jose

 

[ITSNOTAGN]

thanks!