ECM Harness Pins Part Number or Vendor

[salvageV6]

Any one have the part number/manufacturer or source for ECM harness connector pins?

I bought a replacement harness from Caspers but forgot I need a good pin to add to program my Extender Extreme chip.

I may try to get one out of the cut off connector but would prefer a new pin if possible.

TIA

 

[RmvBfrFlght]

Made by Delphi:

Terminals (20-22 awg, .50-.35 MM2), bulk, #: 12089660
Terminals (16-18 awg, 1.00-.80 MM2), bulk, #: 12146448

We carry them, along with Casper's. At one time NAPA carried them in small quantities.

RemoveBeforeFlight

 

[salvageV6]

Thanks for the part numbers, I was lucky to get one good one out after remembering to take the comb off first after cutting the old connector off.

I didn't see them on Caspers website....

 

[RmvBfrFlght]

I should have mentioned that we have a terminal R&R guide on our site:

http://dynamicefi.com/RePinHowTo.php

Not sure why the terminals aren't on Casper's site. I do know that he has sold sets of them along with the crimp tool to folks here. It was after water got into the ECM connectors from leaking t-tops and ruined them.

RemoveBeforeFlight

 

[GNVenom]

http://www.casperselectronics.com/store2/product_info.php?products_id=1100

With the connectors and comb locks.

 

[salvageV6]

Ah I see, I bought the whole thing pre-wired, maybe John could include one extra wire with a socket on it for those that use a programmable chip to install.

Thanks to all for the information.

 

[GNVenom]

PM sent.