fitting for return -8 off regulator

[austinibew145]

what 90 will work for -8 return off the regulator stock rail?

 

[turbofabricator]

Discount Hydraulic Hose.com for a metric to JIC (same as AN) fitting.

Or use this? with an external regulator. Contact Jay Carter for his version. He is going to make them, I think. (if not PM me and I can) He could make it with a -8AN. (no gain, though)

 

[austinibew145]

more info would help!!

 

[austinibew145]

I made this work. I took the 14mm 1.5 adapter from summit and cut off 1/4". I cut it because it didn't thread all the way in to the regulator. that little bit of room made it possible for the 150 degree earls fitting to work. cars pictures by audip82 - Photobucket still looking for better setup

 

[pacecarta]

what would you need a -8 for the return unless your ditching the stock regulator?
the orifice in the stock reg is just about 3/16 , a -6 hose is common and overkill using stock regulator

 

[turbofabricator]

what would you need a -8 for the return unless your ditching the stock regulator?
the orifice in the stock reg is just about 3/16 , a -6 hose is common and overkill using stock regulator

Agree. Except the orafice is really .157" A -6AN will supply 800 PLUS hp @60 psi. (gasoline) If you want the "BIG" hose look, then OK. (or you get a good deal on -8AN only) (hose envy?)

 

[austinibew145]

just preparing for the future. "never fast enough"

 

[austinibew145]

just preparing for the future. "never fast enough"

but don't have funds for fuel rail now