psycho6cyl
Ponies Are For Lil Girls
- Joined
- Feb 11, 2005
- Messages
- 1,908
Just curous if anyone is running them.together. will be running rjc 315 xtf and wanted to run.the side kit w botyom plate but I think.only bottom.is possible?
FMIC & Rad Box in Kit
- Thread starter psycho6cyl
- Start date
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
I bought the kit from GNS but it will not work with the Front Mount (RJC one I have). So I bought the kit from Gbody and that one the sides fit and the bottom will also fit with a little trimming required to clear the Pipes.
The Gbody one is the same material as the original ones.
Hope that hopes. Let me know if I can take some pics as my front end is apart right now.
Dannyo
The Gbody one is the same material as the original ones.
Hope that hopes. Let me know if I can take some pics as my front end is apart right now.
Dannyo
psycho6cyl
Ponies Are For Lil Girls
- Joined
- Feb 11, 2005
- Messages
- 1,908
If you can take pics that would be great. I still have original material and its good condition.. thx
Much easier with the original material vs the GNS kit.
I would rather sell the GNS kit than to cut it up to make it fit.
See attached pics. I have not attached the bottom portion as I will wait until I have the motor in place to ensure the Front mount does not need any adjusting. Once that is done, then I can add the bottom portion. The last pic shows the one side from the GNS kit. As you can see, for it to fit behind this front mount, it would require a little more than just trimming.
It's a great kit, but more for a stock location intercooler or smaller Front Mount. I have another call with a different (smaller) front mount intercooler where this kit might work for me. Just have not got to it yet.
I would rather sell the GNS kit than to cut it up to make it fit.
See attached pics. I have not attached the bottom portion as I will wait until I have the motor in place to ensure the Front mount does not need any adjusting. Once that is done, then I can add the bottom portion. The last pic shows the one side from the GNS kit. As you can see, for it to fit behind this front mount, it would require a little more than just trimming.
It's a great kit, but more for a stock location intercooler or smaller Front Mount. I have another call with a different (smaller) front mount intercooler where this kit might work for me. Just have not got to it yet.
