Fuel pump relay

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

castrolgreen

Member
Joined
Jun 19, 2011
Messages
176
I believe my ecm is not sending a signal to the fuel pump relay is there anyway to bypass that and perhaps wire another trigger wire?? Thanks

Sent from my RM-915_nam_usa_228 using Tapatalk
 
To do this need to supply +12 volts to the relay, this is what the ECM does. To pin A on the relay, or A1 at the ECM (GRN/WHT).

If this turns on the relay while the ECM won't, it is a small transistor on the lower board in the ECM that is likely bad. Easy to replace.

RemoveBeforeFlight
 
there's a green wire on the driver side mines about midway to the valve cover behind the alternator you can use a hot wire to turn on the fuel pump. to see if it's working.I believe when you turn on the key the ecm sends signal for about four seconds to prime the system then shuts off until it gets a rpm signal of about 600 rpm i thing and turns back on the fuel pump someone please correct me if i'm wrong
 
Everything went just like U said my friend so what now???how do I replace????

Sent from my RM-915_nam_usa_228 using Tapatalk
 
Ok mines looks pretty burnt toast could I just replace it & it should be ok or should I worry about the board being toast because it looks little burnt thanks in advance

Sent from my RM-915_nam_usa_228 using Tapatalk
 
If the board is just a little discolored it is OK. If it is showing the fiberglass mat then it would be best to get another ECM.

A picture would help.

RemoveBeforeFlight
 
Back
Top