Greddy boost controller and wastegate

[87GNcospg]

I installed a Greddy Profec B-spec II Boost Controller and was about to install my new HD wastegate actuator but realized that my minumum boost setting (0% on the greddy unit) would be whatever the spring rate is on the actuator, correct?
im 99% positive this is true but i would just like to make sure before i get the car back up and running again.

ill probably be selling this TE style HD actuator very quickly if i have no use for it.

 

[87GNcospg]

well since no one was absolutely sure i took the car out tonight after i finally put some things back together.
had the set boost and gain @ 0% for a test drive. hits 14psi every time no matter what. this boost controller is phenomenal!!! and yes 0% is your stock spring pressure
for all those who are on the fence about electronic boost controllers. . . just get one. i dont have the 2-4 psi variation depending on temperature anymore. which is what you get with a MBC sometimes.

 

[scot w.]

boost controler

Could you please send me the link to the company that you got yours from? I tried the B&E customs web site from the turbobuick main page and some other crap popped up and I even typed in (boostcontroler) and still nothing.. please post the link.. Thank you, Scot w.

 

[87GNcospg]

i got mine off of ebay. ebay always has these listed. they are usually a lot cheaper than what you would pay for with any one else.

 

[gn4u2c]

been running one since 98 they rock. turn the knob more boost :biggrin: set the hi boost selection for my race gas tune. no need to mess with it.