Holley HP EFI + Cruz Harness Install

[THensley]

and AC is it a Input or output?

 

[TType85]

I have the dominator so I have more I/O than I will ever use. But if you are limited to 4/4 it's easy to use them up.

Some ideas

Outputs
1. Fan
2. 2nd Fuel Pump
3. boost+ (PWM boost control)
4. boost- (PWM boost control)
5. Transbrake/Bump
6. AC kick if needed



Inputs
1. Trans Temp (could go to dash if you have a it)
2. Flex Fuel Sensor
3. VSS
4. Alky PSI
5. Dial for boost (AEM 30-2056 AEM 12 Position Trim Pot)
6. Wheel/Driveshaft speed sensor
7. Coolant pressure sensor
8. Oil temp
9. Scramble button
10. Transbrake button
11. etc

 

[THensley]

Thanks This is good food for thought
Outputs
1. Fan. (YES)
2. 2nd Fuel Pump (proudly not)
3. boost+ (PWM boost control) ( I have a Turbo Smart I really like and understand)
4. boost- (PWM boost control)
5. Transbrake/Bump ( No)
6. AC kick if needed ( Yes)
Thats 2 of the 4

Inputs
1. Trans Temp (could go to dash if you have a it) (I have a Holley 5 in it dose not have any IO I'm almost positive ) ( Yes}
2. Flex Fuel Sensor ( no E85 in AZ Bummer)
3. VSS ( yes )
4. Alky PSI (Yes(
5. Dial for boost (AEM 30-2056 AEM 12 Position Trim Pot) (?)
6. Wheel/Driveshaft speed sensor ( I Have looked at them so maybe)
7. Coolant pressure sensor (no wouldn't know what I was looking at)
8. Oil temp ( never thought about it I tossed my cooler years ago because Dan DLS said no need)
9. Scramble button ( no not enough HP to try to find 100 more)
10. Transbrake button (No)
Thats 3 of the 4
VSS and drive shaft about the same Correct ?its can be used to see if its spinning and useful data down track.