lilredss0287
Member
- Joined
- May 24, 2011
does anyone have these or had them? i was curious how did they fit? they seem like the best bang for the buck on the gbody site... are they as good as they say they are??
Is the hye tec header a good header for somebody stock who plans on upgrading until low 11s or high to mid 10s? And what do they cost and where do you get them?
Is the hye tec header a good header for somebody stock who plans on upgrading until low 11s or high to mid 10s? And what do they cost and where do you get them?
The problem with those headers is that the material is so thin they end up cracking in numerous spots. I would go with the TA headers. My 2 cents.
I have TA headers, have never seen the others.... but 14 gauge is considerably thicker than 18 gauge.
Reggie hate to burst your bubble but TA headers are 14 gauge steel, hytech headers are 18 gauge and coated at that, the primary runners are 1 1/2 inch and the crossover pipe is 2 1/4 inch, those the exact numbers i got from him, just trying to clarify things for everyone.