national86
New Member
- Joined
- Jan 26, 2004
I just installed my extender chip yesterday and I started it up it idle great. I check my scan master and the AF was 2 ( I have the translater also).I did some searching on this board and found out, my mass air flow senser is a 3.5 LT1 and not a LS1. I adjusted the knobs on the translator from 0-3 and reset the computer, to see if there was any change ,the AF was still at 2. The car drives great and really pulls hard. Do I need to buy an LS1 maf ?
This is what the scan master read.
AF-2
L8-27-29
BAT-14.1
INT-128
BL-115
MHP
CLT-170
ATS-70
R-825
TPS-.42
IAC-30
o2=730 0.0 knock
This is what the scan master read.
AF-2
L8-27-29
BAT-14.1
INT-128
BL-115
MHP
CLT-170
ATS-70
R-825
TPS-.42
IAC-30
o2=730 0.0 knock