MAFT Pro boost control

[Nigel]

I have a very stock car; valve springs/timing chain replaced otherwise stock mechanicals. Fuel pump, hotwire, 37lb/hr inj, FP reg, alky control, TT alky chip. I would like to initially install a MAFT Pro and use for closed loop boost control. It would also give future growth capability down the road, but for now I only want to be able to run rock solid boost and use it for that, and leave all else the same. The car runs really good otherwise. Can I install the MAFT Pro, boost solenoid adapter, and the boost solenoid, and control boost while leaving the rest of my setup the same, or do I need the tuner pro chip also. The only other option I am considering for boost control is the ISAC, I like the future growth capability of the MAFT, so if I can run it as above I will go with that option. TIA.

 

[Nigel]

Any input, can I use the MAFT Pro in the short term as a boost controller, with out the specific chip, or do I need the tuner pro chip also to control boost. Thanks.

 

[TurboBuRick]

No special chip needed for boost control.

 

[TurboBob]

yes, you can run the unit that way. No special chip needed.

Bob

 

[Nigel]

Gentleman, thank you for the response, upgrade to start. This will be great, because I can dial in boost, then upgrade down the road as time and funds permit. Plus it will allow me to familiarize with the equipment one variable at a time.