Boostin TA
New Member
- Joined
- Aug 27, 2005
Hey guys I need some help on where to go on this one. I just got and hooked up a new Maft Pro Translator and new Maftpro burnt chip from Full Throttle and now the car will not start only cranks. I have all the plug and play wiring from casper so I doubt its a wiring issue. I also have the conversion harness from casper to elimiate my MAF sensor and use the MAP signal. I also have a tps voltage booster and Field Fix harness wired in as well. Im at a loss, I tried putting the old chip (commander) and rehook up the MAF using the MAFTPRO but still no start so I dont think its the chip? I also notice that sometimes when the key is on the fuel pump continues to run, and sometimes it will shut off after the normal 3 seconds. Any help will be appreicated this is frustrating. Car was running fine prior to hooking it up. This is on a TTA.